If a need were to arise to move a stone of that size, say building a road; it could be a good idea to drill a couple of holes into that soft limestone
to move it with a crane and rigging. Just a thought. Perhaps the last one remaining and it was so big they just left it in the median?
Ok, lets suppose that despite Byrd's comment about the last dunking of the area, and that at some time it was close enough to a water way to be of
use.
Those holes are remarkably well preserved, and little other form to the stone.
Generally, I believe moor lines are in line with each other, more or less.
So... dunno what it's from. But it doesn't seem to be 6,000 years old.
Turns out my memory is not as bad as I had thought. 17 1/2 inches just happens to be a common size for well drilling bits and core drill bits of that
size are also available.
I worked on oil rigs in my youth and I remembered correctly that the bits were 17 1/2 inches. These bits are also used to drill water wells and for
masonry work. They are tri-cone bits and the 17 1/2 inch size is what is normally used for oil and large water wells.
After a long absence from the ATS boards I return to find that this old post was still being discussed. Thank you for your answer. I think the drill
bit info nails this one down. Sounds like the stone was rip-rap dug up during the road construction that had been drilled through at an earlier time.