It looks like you're using an Ad Blocker.

Please white-list or disable in your ad-blocking tool.

Thank you.


Some features of ATS will be disabled while you continue to use an ad-blocker.


First Flight of 2020! Drone FPV video - New England CT

page: 1

log in


posted on Jan, 7 2020 @ 10:34 AM
First flight of 2020!
The new motors are on and the tuning is complete! This build is super smooth and very powerful! Flight times are decent. 5min with a 1550mah 5S. I'm using betaflight 4.1.2 with RPM filtering enabled. Motors are Avenger V2 2507 1750kv. The physical build was easy, but tuning it was a pain. The first set of motors I tried did not have enough authority to fight the wind. These motors however, are super strong. This resulted in a super smooth flight. I hope you enjoy!

Build info:
Firmware : BF 4.1.2 | Dshot300 4k/4k | RPM filter enabled

Frame: iFlight XL7 V4 True X 7 Inch 285mm
Flight Controller: iFlight SucceX-E 2-6S F4 30x30 Stack
ESC: iFlight 45A BLheli_S | JSEC firmware for RPM filtering
Motors: Avenger V2 2507 1750kv
FPV Camera: Foxeer Predator Mini v4 1000TVL 1.8mm
VTX: RDQ Mach 3 Video Transmitter 25-1000mW
Antenna: LUMENIER AXII 2 Long Range 5.8GHz (RHCP)
Receiver: FrSky XM+ SBUS 2.4GHz Mini Receiver
Misc: RDQ PCB Wire by Joshua Bardwell
LIPO: Tattu R-Line 1550mah 120C V3.0 5S

posted on Jan, 7 2020 @ 01:15 PM
a reply to: Triton1128

Beautiful! I was however expecting flight time to have improved over 5 minutes, by now.

posted on Jan, 8 2020 @ 02:45 AM
a reply to: Triton1128

It would be nice if you would post photos of your drones. I like your videos but I wanna see your hardware.


log in