First Flight of 2020! Drone FPV video - New England CT

First flight of 2020!
The new motors are on and the tuning is complete! This build is super smooth and very powerful! Flight times are decent. 5min with a 1550mah 5S. I'm using betaflight 4.1.2 with RPM filtering enabled. Motors are Avenger V2 2507 1750kv. The physical build was easy, but tuning it was a pain. The first set of motors I tried did not have enough authority to fight the wind. These motors however, are super strong. This resulted in a super smooth flight. I hope you enjoy!


Build info:
Firmware : BF 4.1.2 | Dshot300 4k/4k | RPM filter enabled

Frame: iFlight XL7 V4 True X 7 Inch 285mm
Flight Controller: iFlight SucceX-E 2-6S F4 30x30 Stack
ESC: iFlight 45A BLheli_S | JSEC firmware for RPM filtering
Motors: Avenger V2 2507 1750kv
FPV Camera: Foxeer Predator Mini v4 1000TVL 1.8mm
VTX: RDQ Mach 3 Video Transmitter 25-1000mW
Antenna: LUMENIER AXII 2 Long Range 5.8GHz (RHCP)
Receiver: FrSky XM+ SBUS 2.4GHz Mini Receiver
Misc: RDQ PCB Wire by Joshua Bardwell
LIPO: Tattu R-Line 1550mah 120C V3.0 5S

a reply to: Triton1128

Beautiful! I was however expecting flight time to have improved over 5 minutes, by now.

a reply to: Triton1128

It would be nice if you would post photos of your drones. I like your videos but I wanna see your hardware.